• Programmable DC power supply with 600W/60V/25A/1 channel
• Simultaneously display the set voltage and current and the output voltage and current
• 4.3-inch TFT true color LCD
• Output time control can be set (0.1-99999.9 seconds)
• Supports output voltage and current slope setting

Programmable DC power supply with 600W/60V/25A/1 channel

Simultaneously display the set voltage and current and the output voltage and current

4.3-inch TFT true color LCD

Output time control can be set (0.1-99999.9 seconds)

Supports output voltage and current slope setting

The UNI-T UDP6900-series DC power supplies are available in versions with differing peak output parameters. Please see the table below for a comparison.

Voltage drops can occur when long wires connect the power supply to the load. Remote sense allows measurements to be made on the terminals of the device under test. Connect the S+ and S- (sense terminals) to the device under test and the power supply as shown in the image. The remote sense feature will detect voltage at the device and compensate for any drop.

The UDP6900 series power supplies have a built-in 4 1/2-digit voltmeter function which can measure DC voltages from 0.001V to 65.000V (160.0V on the UDP6933B and UDP6935B). The voltage terminal inputs are located on the rear of the instrument.

Note: Only DC voltage can be measured.

The UDP6900 series power supplies offer three slope modes:

Normal Mode: The voltage and current output values correspond to the set value, and the slope parameter cannot be set.

VSR (Voltage Slope) Mode: The initial current is the set value, and the voltage changes to the set voltage according to the set step. The voltage rise and voltage fall slopes can be set.

ISR (Current Slope) Mode: The initial current is the set value, and the current changes to the set current according to the set step. The current rise and current fall slopes can be set.

Built-in communication based on the RS485 standard enables connection of multiple power supplies. The communication protocol can be set to SCPI, Multi-SCPI, or Modbus. The primary power supply will be connected to a PC for remote control as shown.