The Transforming Technologies CS123 Snap Screw Set provides a 10mm stud in worksurface rubber or vinyl. Includes a screw base and 10mm stud. Installs 10mm studs into ESD workstation materials and provides a solid connection with a wide screw base.

How to Install Snap Screw Sets

1. Place ESD matting on the workstation. Locate the safest, and most convenient grounding point (outlet).

2. Choose which side of the mat has the closest or most convenient access to the grounding point.

3. Locate an area 1 –2 inches from each corner of the mat on the side that was determined in step 2.

4. Make a hole in the mat large enough for the screw to slide through.

5. Place the stud onto the screw and turn clockwise until the stud is flush with the ESD mat.