NaviTEK NT Pro Specification |
Connectors |
RJ45 |
Used for |
- Cable Test
- Ethernet Test |
Connector type |
Lifejack with user-replaceable contacts |
Optical |
Used for |
Ethernet Test |
Connector type |
SFP socket |
USB |
Used for |
- Software Update
- Results transfer
- 802.1x certificate transfer
- Import/export of config
- WiFi Adapter |
Class |
Host |
Connector type |
A |
USB type |
1.1 |
Power |
Used for |
Battery charging
Mains powering via adaptor |
Connector type |
2.5mm pin power jack |
Polarity |
Centre pin positive |
Voltage |
12v |
Current |
2 A |
Location |
Bottom of optional power module
(Not present in standard alkaline battery pack) |
Controls |
Push button |
Used for |
Power ON/OFF |
F1 to F3 |
Used for |
Screen-defined functions |
Cursor and ENTER |
Used for |
User interface navigation |
Escape |
Used for |
Return to previous menu |
Autotest |
Used for |
Launch of automatic test function |
Push button |
Used for |
Escape from exceptional lockup condition |
Displays |
LCD |
Used for |
Display of setup functions and results |
Location |
Front |
Size |
2.8 inch diagonal |
Type |
QVGA Colour |
Pixels |
240 x 320 |
Charger LED |
Used for |
Indication of charging status |
Colour |
Green |
Location |
Bottom of standard power module (Not present in optional alkaline battery pack) |
RJ45 Link LED |
Use |
ON indicates link UP |
Colour |
Green |
RJ45 Activity LED |
Use |
Flashing indicates link activity |
Colour |
Green |
Optical Link LED |
Use |
ON indicates Optical link UP |
Colour |
Green |
Optical Activity LED |
Use |
Flashing indicates Optical link activity |
Colour |
Green |
Ports |
Setup |
Auto Negotiation |
Enabled
Disabled |
Speed |
10Mb/s
100Mb/s
1Gbps |
Mode |
Full Duplex
Half Duplex |
MDI |
AUTO
MDI
MDIX |
Min Rx Size |
19:99 bytes |
MAC |
Factory set |
VLAN |
Enabled / Disabled
VLAN ID – 0 to 4094
VLAN Priority – 0 to 7 |
802.1x |
Enabled / Disabled
EAP Method
EAP-MD5
EAP-MSCHAPV2
EAP-GTC
EAP-TLS
EAP-PEAP/MD5
EAP-PEAP/MSCHAPV2
EAP-PEAP/GTC
EAP-PEAP/TLS
EAP-TTLS/MD5
EAP-TTLS/MSCHAPV2
EAP-TTL/GTC
EAP-TTLS/TLS
Username
Password
Certificate
Import password
Root/CA certificate |
Results |
Link pulse polarity |
Normal or Inverted |
Link pulse height |
Normal or Low |
Tests |
Ethernet Mode |
Ping4
Ping6
Trace Route4
Trace Route6
Hub Blink
Netscan
Loopback
Auto (Ping DNS/Gateway/Internet, Trace Route,
Netscan) |
Cable Mode |
Wiremap
Tone Generator
Auto (Wiremap) |
Service Detection |
Detected Services |
PoE (802.3af/at. Not Cisco pre-standard)
ISDN S
PBX
Unknown |
Supported SFPs |
The following SFP types are supported. Use of other types of SFP is possible but correct operation is not guaranteed. |
SFP Type SX |
Manufacturer Part # |
Avago AFBR-5705Z / Apac LM28-C3S-TI-N-DD |
Speed |
1Gbps |
Fibre Type |
Multimode |
Wavelength |
850nm |
Connector Type |
LC Duplex |
SFP Type LX |
Manufacturer Part # |
Avago AFCT-5705Z |
Speed |
1Gbps |
Fibre Type |
Singlemode |
Wavelength |
1310nm |
Connector Type |
LC Duplex |
SFP Type ZX |
Manufacturer Part # |
Apac LS48-C3U-TC-N-DD |
Speed |
1Gbps |
Fibre Type |
Singlemode |
Wavelength |
1550nm |
Connector Type |
LC Duplex |
Setup |
Speed |
1Gb/s |
Min Rx Size |
19:99 |
MAC |
Factory set |
VLAN |
Enabled / Disabled
VLAN ID – 0 to 4094
VLAN Priority – 0 to 7 |
802.1x |
Enabled / Disabled
EAP Method
EAP-MD5
EAP-MSCHAPV2
EAP-GTC EAP-TLS
EAP-PEAP/MD5
EAP-PEAP/MSCHAPV2
EAP-PEAP/GTC
EAP-PEAP/TLS
EAP-TTLS/MD5
EAP-TTLS/MSCHAPV2
EAP-TTL/GTC
EAP-TTLS/TLS Username
Password
Certificate
Import password
Root/CA certificate
|
Tests |
Optical |
Tx Power dBm (using a specified SFP)
Rx Power dBm (using a specified SFP) |
Ethernet Mode |
Ping4
Trace Route4
Hub Blink
Netscan
NET TEST (Ping, Trace Route, Netscan) |
Cable Tests |
Setup |
Cable Type |
2 Pair
4 Pair 568A
4 Pair 568B |
Colour Scheme |
|
NVP |
Fixed 72%
Custom 59% - 89% |
Termination Type |
None |
Open |
Active Remote |
#1 - #12 |
Tests (No Termination) |
Faults |
Open circuit by pair
Short circuit by pin |
Length of pair |
Metres / Feet (Set in System Setup)
Range 3-100m / 10-330ft |
Tests (Active Remote Termination) |
I/D – Remote #
Indications on Remote |
Voltage Warning (>±10volts on any pins)
Pass/Fail |
Faults |
– Open circuit by pin
Short circuit by pin
Crossed pairs
Split pairs
Bridged shorts
Remote shorts |
Length of pair |
Metres / Feet (Set in System Setup)
Range 3-100m / 10-330ft |
Setup |
No of Tones |
3 |
Wire I/D |
Tone applied to one of 8 pins relative to the other 7
Tone applied across one of 4 pairs |
Test |
Audible tone detected using compatible tone probe |
Ethernet Tests |
Setup |
Addressing |
DHCP
Static |
Numerical |
Address
Netmask
Gateway
DNS1
DNS2 |
Setup |
IPv6 Enable |
Enabled
Disabled |
Addressing |
Stateful (DHCPv6)
Stateless
Static |
Numerical |
128bit HEX IP address |
Network Prefix |
64 bit
128 bit |
Setup |
Target |
Numerical address
URL (Store up to 10) |
Count |
1 to 999999 |
Pause |
1 to 5 Sec |
Length |
8 to 1000 bytes. |
Results |
Info |
READY
IN PROGRESS
PASSED
NO RESPONSE
UNKNOWN HOST |
Tx Count |
1 to 999999 |
Rx Count |
1 to 999999 |
Delay(ms) |
Minimum
Average
Maximum |
Setup |
Target |
Numerical address
URL |
Max Hops |
2 to 100 |
Timeout |
2 to 30 sec |
Type |
ICMP
UDP |
Results |
Info |
READY
IN PROGRESS
PASSED
NO RESPONSE
UNKNOWN HOST |
Hop |
Numerical address |
Delay(ms) |
t1
t2
t3 |
Setup |
Netscan |
Local
Custom
Disabled |
IP Address |
IPv4 address |
Scan Range |
0 (class C /24)
1 (class C /20)
2 (class B /16) |
Results |
|
List of IPv4 hosts List of IPv6 hosts |
Test |
Sequence |
Off/10/Off/100/Off/1000 Mb/s (RJ-45)
Off/On (Optical) |
Statistics |
IPv4 |
|
info: listening, assigned, DHCP failed DHCP or Static
IPv4 Address
IPv4 Netmask
IPv4 Gateway
IPv4 DNS1
IPv4 DNS2 |
IPv6 |
|
Enabled or Disabled
info: listening, assigned, DHCP failed
Stateful (DHCPv6) or Stateless or Static
IPv6 Address
IPv6 Network Prefix, 64 bit or 128 bit
IPv6 Link Address
IPv6 DNS |
Discovery |
|
LLDP/CDP/EDP
Protocol
MAC address
Hostname / address
Port Name
Max 10 hosts |
Detection |
1 Level VLAN ID Rx |
Results |
PORT |
PoE Voltage 0 – 60V
PoE Pairs 12/36 or 45/78
Speed, Duplex
MDI / MDIX
Signal Level Polarity |
PARTNER |
10M-HD
10M-FD
100M-HD
100M-FD
1000M-HD
1000M-FD |
Results |
ERRORS |
Collisions
FCS Errors
Undersize
Oversize
Jabbers
Bad Length |
Bargraph |
Direction |
Rx |
Format |
Percentage of Link rate
Peak value |
Time Interval |
1 min
10 min
60 min |
Storage |
Internal storage |
Number of configurations – 2 (Current & Factory settings) |
Export/Import |
Port |
USB |
Format |
xml |
802.1x |
Max number |
10 |
Internal storage |
Max Number of Jobs (Projects) |
50 |
Max Number of result sets per Job |
5000 depending on tests performed |
Max total number of result sets |
Up to 5000 depending on tests performed. |
Export |
Port |
USB
Wi-Fi |
Format |
PDF
CSV (summary only) |
System |
Owner |
Details |
Name
Company
Address
Phone |
Preferences |
Language |
English
French
German
Spanish
Italian
Portuguese
Chinese |
Auto off |
Disabled
3 mins
10 mins
30 mins |
Backlight |
Always On
Dims to 50% after 3 mins |
Length Units |
Meters
Feet |
Date Format |
dd/mm/yy
mm/dd/yy |
Time Format |
12 hour
24 hour |
Software update |
Upgrade |
Via USB |
General |
Internal Clock |
Used for |
Timestamping results |
Autonomy |
Up to 1 day with battery removed |
Battery |
Supported Types |
Standard power module (4 x AA NiMH cells)
Alkaline battery pack with 4 AA cells |
Autonomy |
Up to 5 hours (power module only) |
Recharge time |
3 hours (Power module only) |
Battery level Indication |
Full
2/3
1/3
Empty |
Dimensions |
Length |
175mm |
Width |
80mm |
Depth |
40mm |
Weight |
Unit |
0.22kg |
Batteries |
0.18kg |
Temperature |
Operating |
0°C to 40°C |
Storage |
-20°C to 70°C |
Relative Humidity |
Min |
5% |
Max |
90% non-condensing |
EMC |
EN 55022:2006 / A1:2007
EN55024:1998 / A1:2001 / A2:2003 |
Safety |
IEC 60950-1:2005+A1:2009/EN 60950-1:2006+A1:2010 |