• Condmaster Ruby Module Multi-Channel Simultaneous Vibration Monitoring
• Measurement requires set-up of 2 or 3 vibration measuring assignments with identical parameters
• Allows study of machine movement in two/three dimensions by monitoring phase angle difference
• Condmaster Ruby displays the RMS values for DISP, VEL and ACC for all channels
• Requires FFT with symptoms (MOD134) or EVAM (MOD135) to be active

The MOD 192 multi-channel simultaneous vibration monitoring, including both two-channel and three-channel measurements, is a module function in Condmaster Ruby that requires either 'FFT with symptoms' (MOD134) or 'EVAM' (MOD135) to be active. This type of measurement allows the user to study machine movement in two/three dimensions by observing the difference of the phase angles measured on the channels.

Measurement requires the set-up of two/three vibration measuring assignments with identical parameters. A multi-channel measuring cable is used to connect both transducers to the Leonova vibration transducer input. The procedure is the same as for the corresponding measurement with a single transducer. For Intellinova Parallel EN, a multi-channel measurement must be set up within the same group of four channels, i.e. within channel 1-4, 5-8, 9-12 or 13-16. Condmaster Ruby displays the RMS values for DISP, VEL and ACC for all channels. Three graphs are available for each measurement: (1) Spectrum (2) Phase spectrum (3) Time signal