Rigol DG1000 Series Arbitrary Waveform Function Generators

RIGOL DG1000 series function/arbitrary waveform generators use Direct Digital Synthesis (DDS) technology. They can generate accurate, stable, clean, low distortion signals.  Each channel can create sine, square, ramp, pulse,or noise signals and coordinate with the other channel. These instruments each have 2 channels with the 2nd channel having a lower voltage output. Each DG1000 can output 4055 point arbitrary waves.

Applications

• Analog Sensor
• Practical Environment Signals
• Circuit Function Test
• IC chip Test

Easy to Use Design

• A variety of display modes
• Clear graphical interface
• Support  for  Chinese  and  English menu and input
• Push-help makes information getting more convenient.
• File management (support for USB flash device and local storage)

Dual Channel Output, Built-in and Editable Arb Waveform

Dual Channel Output: Separately setup the wavefrom and parameter as well as the output state of two channels. The phases from two channels could be synchronous while outputting based on the "AligPha" function from operation menu.

Built-in Waveform Output: The instrument has 48 built-in arbitrary waves (contains DC) which including common, math, engineering, window function and other common waves.

Editable Arb Waveform: Enable to edit and output a arbitrary wave with 14bits, 4kpts. In addition, the instrument provides 10 nonvolatile memories for storing custom arbitrary waves. According to Ultrawave, more waves could be edited and saved.

Abundant Modulation Functions, Sweep, Burst

Abundant Modulation Functions: Support AM, FM, PM and FSK, the modulated waveforms are intuitively shown on the screen. It can be used in Education & Training area proverbially.

Sweep: It can generate "sweep" from the start frequency to the stop frequency during appointed sweep time (1 ms ~ 500 s) you specify. Sweeping can be generated by Sine, Square, Ramp or Arbitrary waveforms.

Burst: It can generate pulse sequence for a variety of waveform function, and the waveform could continuousely cycle within specific time or apply external gating signal.

Channel Coupling and Copy

Channel Coupling: Once you setup the base channel and the Frequency/Phase deviation of the two channels, the Frequency/Phase of the other one will vary with the base channel and will still keep the deviation you have selected.

Channel Copy: According to this function, the parameters from one channel could be copied to another channel with no change of the waveform shape.

Built-in Frequency Counter

counter coulde be used to measure these parameters: frequency, period, duty cycle, positive pulse width and negative pulse width within the range of 100 mHz to 200 MHz.

Two modes of counter are available:

Auto mode: The coupling mode, sensitivity, trigger level and the switch of high frequency reject could be set automatically.

Manual mode: DC/AC, sensitivity (low, mid, high), trigger level, the switch of high frequency reject could be set manually.