| RESISTANCE RTT |
At 10 volts, 12% RH (Rtt) 106 – 108 ohms
At 100 volts, 50% RH (Rtt) 106 – 108 ohms |
| RESISTANCE RTG |
At 10 volts, 12% RH (Rtg) 2.5x107 ohms
At 100 volts, 50% RH (Rtg) 8.5x106 ohms |
| VOLTAGE GRADIENT |
Voltage apparent on the mat surface 5 inches from a discharge point (during electrification to 5,000 volts): Less than 25 volts |
| STATIC DECAY TIME |
5,000 volts to less than 50 volts in .01 seconds |
| CHARGE RETENTION |
Residual voltage: <10 volts
Initial voltage of 5,000 volts dissipated upon contact with installed samples.
Residual voltage after plate lift was <10 volts. |
| SIZE |
2 x 4 foot (24 x 48 inches) |
| THICKNESS |
2 mm, lays flat, will not curl, not chip |
| COLOR |
Grey with low reflecting satin finish to reduce glare |
| HEAT TOLERANCE |
Withstands frequent contact with hot soldering irons |
| Q007B Common Point Ground Connector |
| DIMENSIONS (LxWxH) |
2.12" x 0.9" x 0.9" (5.385cm x 2.286cm x 2.2286cm) |
| CASE MATERIAL |
Fire Retardant ABS |
| COLOR |
Green |
| CONFIGURATION |
3 standard banana jack inputs, Brass Grounding Pin, 2 FR ABS Spades |
| PGC-015G Green 15 Foot Ground Cord |
| LENGTH |
15 feet (4.6 meters) |
| RESISTOR |
One megohm (±10%) resistor molded into snap connection |
| COLOR |
Green |
| PWS-620 Metal Band Wrist Strap CUFF ASSEMBLY |
| CONSTRUCTION |
Made from jewelry quality stainless steel, non-rusting, tested to MIL STD 202 Method 101 |
| THICKNESS |
3.5mm, average weight 33 grams
Manufactured to 130mm circumference with 5 10mm nylon expansion l links |
| ELECTRICAL PROPERTIES |
Outer band: insulative at 500V per unit millimeter, coating is polyurethane based polymer
Inner band: Conductive - <1.0x104 |
| QUALITY CONTROL |
Each band is date and lot coded to total quality control and auditing |
| ELASTICITY |
Expansion ratio 1.5:1 |
| SNAP/SIZE |
4mm post snap for ground cord, non rusting, tested to MIL STD 202 Method 101 |
| COLOR |
Black |
| MARKINGS |
Prostat logo |
| MEETS OR EXCEEDS |
DOD-HDBK-263, DOD-STD-1686, EOS/ESD Std. No. 1-1987, EN10015/1 |
| UL LISTED |
File E 157590 |
| CORD ASSEMBLY |
| CORD |
Heavy Duty, Lightweight construction of Single bundle, laced tensile conductors reinforced with synthetic fibers. Cord Diameter: 0.06" Coil Diameter: 0.26" Alligator clip supplied. |
| RESISTOR |
One megohm (±10%) resistor molded into snap connection |
| GROUND CONNECTION |
Standard banana plug |
| WARRANTY |
Warranted for One Year against mechanical and electrical defects. |
| CORD EXTENSION |
Full extension greater than 13 feet; Working Length greater than 10 feet. |
| TESTED |
Provides over 100,000 bending cycles per EOS/ESD-S1.0-1987 procedures. |
| WARNING |
A one-megohm resistor has been molded into the plastic cap on the ground cord fastener. DO NOT REMOVE. If it becomes damaged, replace ground cord immediately. Do not use in areas where the individual may come in contact with electrical circuits exceeding 250 volts. |
| CAUTION |
The Prostat wrist strap is for static control. It will not reduce or increase your risk of receiving electrical shock when using or working on electrical equipment.
Follow the same procedures you would use without wrist straps, including:
* Make certain that equipment having a grounding type plug is properly grounded.
* Make certain that you are not in contact with grounded objects other than through the strap. |
| SPERRY GFI6302 GFCI OUTLET TESTER |
| OPERATION RANGE |
120 VAC, 60 Hz; CAT III 300V |
| INDICATORS |
Visual Only |
| OPERATING ENVIRONMENT |
32° - 104° F (0 - 32° C)
80% RH max., 50% RH above 30° C |