Remote Area Light
The 9490 features the ability to be used while charging. When the charger is connected to AC power and the product is switched on, the 9490 will automatically select a light level to allow continuous operation. - automatic mode. (In this mode, the battery level will remain constant. The light will be at a 50% level.)
Manual adjustment of the brightness will still be possible. If the brightness is increased, then automatic mode will be exited, a new runtime will be computed based upon the new operating conditions. The battery level and the display will revert to the normal IC mode, (or preset mode if the bottom left button has been used).
If the brightness is decreased, the unit will remain in continuous mode (and the battery will charge up slowly).
Bluetooth Operation
- The 9490 is equipped with Bluetooth capability and you are able to operate it via the Pelican RALS (Remote Area Lighting Systems) app.
Flash Mode
- Press and hold the power button for 3 seconds until flashing begins, then select the required power level.
- To switch flashing mode off, press the power button again.
Power Pack
- The 9490 power pack is removable. This allows for continuous use of the product by replacing it with another fully charged power pack when required.
- To remove the power pack simply release the clips and lift via the handle.
Power Pack Level
The power pack is equipped with a power level monitor which remains permanently illuminated to tell the user how much power the battery contains. The level monitor will glow brightly when the product is switched on and dim when not in use.
While the product is switched on, the number of segments illuminated in the level monitor will gradually reduce over time. The product will switch off soon after a single red flashing segment is displayed. Once the product has switched itself off, the single red segment in the level monitor will continue to flash, indicating that a recharge is required.
Power Pack Charging
- The power pack can be charged inside or outside of the main 9490 housing.
- Remove the dust cap from the charging socket and plug in charger.
- Connect the charger to the mains AC power supply.