Mitutoyo U-Wave Fit
The U-WAVE Fit can be used with most of the calipers and micrometers equipped with the Digimatic SOC output function and uses the Mitutoyo Digimatic protocol to easily transfer data measurements wirelessly to the U-Wave-R receiver (sold separately), from there it is sent PC. Compared to U-Wave T, the compact and thin design provides better operability and fit to digimatic micrometers and calipers (excludes micrometers and calipers over 12in, MDH, QuickMike, and some specialty hand tools). A small connection unit (sold separately) is required from the instrument to the transmitter.
U-WAVE-TC Transmitter for Calipers (Mitutoyo 264-620/621)
Just like the U-WAVE-TM, the U-WAVE-TC is designed to fit on most Mitutoyo Caliper models, allowing for less obstruction of the inside jaws and greater comfort of use. This transmitter is also available in an IP67 Coolant Proof and Buzzer type and is serialized to identify the data source. The transmitter can be connected to the gage by either a Standard Connector or an IP67 Coolant Proof Connector that preserves the same IP Rating as the gage.
U-WAVE-TM Transmitter for Micrometers (Mitutoyo 264-622/623)
The U-WAVE-TM Transmitter is specifically designed to fit on most Mitutoyo micrometer models, allowing for less obstruction and greater comfort of use. Each transmitter is serialized allowing the data sent to be identified. Transmitters are available in IP67 Coolant Proof and Buzzer types and are connected to the gage by an IP67 Coolant Proof Connector.
Please see Guide and Brochure in the Documents section for instrument compatibility, requirements, and additional specifications/information.