Recommend to a Friend

Tool could be better

3.0

As with any new tool or device I put it through a series of tests . First I read all or many of the online comments good and bad to get a handle on what to look for as I test the features . Here are the cons first---#1 Aligning the tubing in the blocks to the correct position even using the little flip over guide is a real challenge then trying to tighten it down and keep it aligned will take the patience of a saint !!! #2 The pressure needed to hold the tubing in place is far more than can be achieved using the clamping handle . To get the needed pressure with out hurting my hand I now keep in the kit a 10 inch by 1/2 inch copper pipe to leverage the force , that problem solved . #3 The pointed die is not finished nice it has ridges from the lathe that made it and they needed to be buffed out by hand with a sheet of #600 wet sad paper to make due the invert correctly with out nicks . #4 don't think the invert die will line up straight automatic on the piston shaft all the time !!!! I hope this helps by ---HERB THE POWERMAN---

---HERB THE POWERMAN--- on Jun 04, 2018 I found this helpful (3)