| Model |
WaveJet Touch 334 |
WaveJet Touch 354 |
| Bandwidth (@50 Ω) |
350 MHz |
500 MHz |
| Rise Time |
1 ns (typical) |
750 ps (typical) |
| Input Channels |
4 |
| Vertical Resolution |
8-bits |
| Sensitivity |
50 Ω: 2 mV/div – 2 V/div; 1M Ω: 2 mV/div – 10 V/div |
| DC Gain Accuracy |
±(1.5% of + 0.5% of Full Scale) |
| Bandwidth Limiting Filter |
200 kHz, 2 MHz, 20 MHz, 100 MHz |
| Maximum Input Voltage |
50 Ω: 5 Vrms; 1M Ω: 400 Vpk CAT I |
| Input Coupling |
50 Ω: DC, GND; 1M Ω: AC, DC, GND |
| Input Impedance |
50 Ω: ±1.0 %; 1M Ω: ±1.0% || 16 pF (typical) |
| Offset Range |
2 mV/div - 50 mV/div: ±1 V, 50.2 mV/div - 500 mV/div: ±10 V, 502 mV/div - 10 V/div: ±100 V |
| Offset Accuracy |
2 mV/div - 50 mV/div: ±(0.5% of offset value + 0.5% FS + 1 mV)
50.2 mV/div - 500 mV/div: ±(0.5% of offset value + 0.5% FS + 10 mV)
502 mV/div - 10 V/div: ±(0.5% of offset value + 0.5% FS + 100 mV) |
| Sampling Rate (Single Shot) |
2 GS/s (interleaved), 1 GS/s (all channels) |
| Sampling Rate (Equivalent Time) |
100 GS/s |
| Record Length |
5 Mpts/Ch (interleaved), 2.5 Mpts/Ch (all channels) |
| Acquisition Modes |
Real Time, Peak Detect, Average, High Resolution |
| Real Time Timebase Range |
1 ns/div - 50 s/div |
500 ps/div - 50 s/div |
| Roll Mode Timebase Range |
50 ms/div - 50 s/div |
| Peak Detect Period |
1 ns |
| Timebase Accuracy |
10 ppm (typical) |
| Standard Probes |
10:1 Passive Probe (one per channel) |
| Probing System |
BNC with Probe Sense Ring |
| Modes |
Auto, Normal, Single, Stop |
| Sources |
Any input channel, External, Ext/10, or line |
| Coupling |
DC, AC, HFREJ, LFREJ, Noise Reject |
| Trigger Types |
Edge, Edge ALT, Edge OR, Pulse Width, Period, Pulse Count, Dropout, TV, Logic, I 2 C, SPI, UART |
| I2C |
Trigger on START, RESTART, STOP, ADDR, DATA, ADDR+DATA, Data Length, or Missing ACK. 7 or 10-bit ADDR
are supported with full Read, Write, or R/W = “Don’t Care”. DATA conditions support <=, <, =, >, >=, <>, in range,
out of range, and don’t care (EEPROM mode only). DATA can be setup in Hexadecimal (1-5 bytes supported).
Full range of bit rates supported for Standard, Fast, Fast-Mode Plus, and High speed mode. Bit rate is auto-
detected. Trigger on any analog channel, EXT, or EXT/10. |
| SPI |
Trigger on DATA. DATA can be setup in Binary (any combination of 0, 1, or X for 4-96 bits). All bit rates are
supported and are auto-detected. Trigger on any analog channel, EXT, or EXT/10. |
| UART / RS-232 |
Trigger on START, STOP, DATA, or Parity ERROR. DATA can be setup in Hexadecimal (1 byte supported) or
Binary (any combination of 0, 1, or X for 5-8 bits). All bit rates are supported between 1 kb/s and 1 Mb/s.
Trigger on any analog channel, EXT, or EXT/10. |
| Measure |
Base, Cycle Mean, Cycle RMS, Duty Cycle, Fall Time (90-10%), Fall Time (80-20%), Frequency, Integral, Maxi-
mum, Mean, Minimum, Number of +Pulses, Number of -Pulse, +Overshoot, -Overshoot, Peak-Peak, Period,
+Pulse Width, -Pulse Width, Rise Time (20-80%), Rise Time (10-90%), RMS, Skew, Skew@level, Top, Top-Base |
| Zoom |
Use front panel QuickZoom button to zoom all waveforms in a separate zoom grid |
| Math |
Sum, Difference, Product, Integral, Derivative, FFT (up to 8 kpts with Rectangular, Von Hann, or
Flat Top windows) |
| Replay Mode |
Look back at the history of waveform acquisitions (maximum 2,048 acquisitions) |
| Display Size |
7.5” TFT-LCD Touch-Screen |
| Display Resolution |
640 x 480 VGA |
| Aux Out |
Trigger output or pass/fail output |
| USB |
USB host port for flash drives, USB device port for connecting to PC and direct printer connection |
| LAN |
10/100Base-T Ethernet interface (RJ-45 connector) |
| GPIB |
Supports IEE-488.2 |
| Dimensions (HWD) |
7.5"H x 13"W x 4.9"D (190 mm x 330 mm x 124 mm) |
| Weight |
3.7 kg (8.16 lbs) |
| Temperature |
Operating: 0 °C to 40 °C; Non-Operating: -20 °C to 60 °C |
| Humidity |
Maximum 80% relative humidity (non-condensing) up to ≤ 30 °C, Upper limit derates to 55% relative humidity
(non-condensing) at 40 °C |
| Altitude |
Operating: 3,000 m (9,843 ft) max at ≤ 25C; Non-Operating: Up to 12,192 meters (40,000 ft) |
| Voltage |
100 - 240 V (± 10%) at 50 / 60 Hz (± 5%), 100 - 120 V (± 10%) at 400 Hz (± 5%) |
| Power Consumption (Max) |
50 W |
| CE Certification |
Low Voltage Directive 2006/95/EC; EN 61010-1:2010, EN 61010-2-030:2010
EMC Directive 2004/108/EC; EN 61326-1:2013, EN61326-2-1:2013; RoHS2 Directive 2011/65/EU |
| UL and cUL Listing |
UL 61010-1, UL 61010-2-030:2010, 3rd Edition; CAN/CSA C22.2 No. 61010-1-12 |