• AC/DC high-sensitivity current probe, low-noise (≤ 250 µArms), measure down to 1mA/div
• Bandwidth: DC to 150 MHz
• Rise time (calculated): 2.67ns
• Max current (continuous): 30 ADC, 30 Arms (with external power adapter)
• Amplitude accuracy: +/- 1% rdg. +/-5 mA to 30 Arms 

The Keysight N7026A is Keysight’s highest sensitivity clamp-on current probe. It has up to 5x lower noise than our other clamp-on current probes with 0.1V/A output voltage rate. This enables you to measure down to 1 mA/div with much higher accuracy. The N7026A, when used with an InfiniiVision or Infiniium oscilloscope, provides highly accurate, low-current waveforms for improved debugging and analysis.

Wide Input Range

It also has a wide input range, up to 30 Arms or 40 A peak. To achieve the most comprehensive input range, you must use the external AC power adapter that comes with the probe. Without the external power adapter, you can achieve up to a 5 Arms or 5 A peak input range. The oscilloscope automatically synchronizes with the corresponding power source when inserting or removing the AC adapter. In either case, a degauss operation will occur.

Degaussing Made Easy

Degaussing and eliminating the offset error is critical for accurate measurement with a clamp-on current probe. A degauss button is included in the design of this probe. One push of the button will perform a degauss operation. Pushing and holding the button for > 2 sec will perform a degauss and autozero the DC offset. When using the degauss button, the current sensor should be locked with no current flowing. Alternatively, the same operation can be performed from the oscilloscope GUI.