• Auxiliary output option
• Compatible with 6813C AC power source
• 6813C sold separately
• 6813C CAN ACCOMMODATE ONLY ONE OF THE FOLLOWING OPTIONS – 019, 020 or 026
• Provides an auxiliary 26 Vrms output located on the rear panel of the AC source

Option 026 consists of an auxiliary 26 Vrms output located on the rear panel of the AC source. This is a programmable output with a maximum output current of 100 mArms. The output frequency tracks the frequency of the main output of the AC source. Option 026 adds the following capabilities:

• AC voltage and phase are programmable, in immediate mode only
• Software calibration is available for both voltage and phase. Calibration is performed at a single frequency (400 Hz). Note that there is no compensation for frequency-dependent voltage variation or phase shift
• The auxiliary output waveform and frequency are always the same as the main output
• For a sine wave output, the maximum programmed rms voltage value is 26.02 V. For any waveform, the programmed rms voltage value may not result in a peak voltage of more than 36.8 V
• Current limit is not programmable
• DC voltage is not available

The image below shows the rear panel connections for option 026. Please note, the picture below is a generic image for the 6800C series, also showing additional options and configurations.