| PB-505 Deluxe Analog & Digital Design Workstation |
| Power |
3-wire AC line input (115V/230V 50-60Hz or 230V 50Hz)-(specify when ordering ) with power indicator. |
| Fixed DC output |
+5VDC @ 1.0A, ripple <5mV |
| Variable DCO/P |
+1.3V to +15V @ 0.5A, ripple <5mV |
| Variable DCO/P |
1.3V to -15V @ 0.5A, ripple <5mV |
| Fixed AC O/P |
12.6 VAC Center tapped @ 100mA |
| Frequency Range |
0.1Hz to 100KHz in six ranges |
| Output Voltage |
0 to +10V (20Vp-p) |
| Output Impedance |
600 ohms (except TTL) |
| Output current |
10 mA max., short circuit protect-ed |
| Output waveforms |
Sine, Square, Triangle, TTL |
| Sine wave |
Distortion < 3% (10Hz to 100KHz) |
| TTL pulse |
Rise and fall time <25ns
Drive 10 TTL loads |
| Square wave |
Rise and fall time <1.5?s |
| Logic Indicators |
16 LED?s 8 red to indicate logic high, 8 green to indicate a logic low. |
| Logic Probe |
Built-in TTL/CMOS compatible logic probe.
Captures fast single shot events and pulse trains.
Input impedance 300K ohm, overload protection +50VDC, min.. detectable pulse width 100nsec. TTL threshold low +0.8V high +2.25V, CMOS threshold low +30%Vcc high +70%Vcc. Memory mode, latches on first transition and LED remains on until probe is reset |
| Debounced Push-Button (Pulsers) |
Two push-button operated, open-collector output pulsers, each with one normally-open and one normally- closed output. Each output can sink up to 25mA. |
| Potentiometers |
One 1K ohm, one 10K ohm, all leads available and uncommitted. |
| Switches |
Two SPDT slide switches, all leads available and uncommitted. |
| BNC Connectors |
Two BNC connectors, pin available and uncommit-ted, shell connected to ground. |
| Logic Switches |
8 individual SPDT logic switches, one side of all eight switches connected and switchable to +5V or ground, other side of all eight switches separate, and uncommitted. |
| Speaker |
0.25W, 8 ohm |
| BCD to 7 Segment Display |
2 BCD to 7 segment display circuits are provided including decoder/driver circuitry. Tie points: 5 per each unit. |
| Breadboarding Area |
A total of 3360 uncommitted tie-points, available on velcro breadboard plate. Two QT-59B, bus strips. Fifty tie-points for each +5V, variable +15V, and ground if desired. |
| Enclosure |
Steel case |
| Weight |
10 lbs (4.5kg) |
| Overall Dimensions |
4.5in (H) x 15in (W) x 10.75in (D) (11.4 x 38.1 x 27.3 cm) |
| Part Number |
104-0505 |