• CAT IV / 600 V Safety Rated
• 2062R Receiver, 2000T Transmitter, and i400 AC Current Clamp
• Accessory Kit and Hard Case Included
• Smart Sensor mode for energized wire detection and visualization
• High-resolution 3.5” TFT LCD color display 

The Fluke 2062 Advanced Pro Wire Tracer accurately and safely troubleshoots energized and de-energized wires in residential, commercial, and industrial environments up to CAT IV 600 V. It’s designed to protect you from the most dangerous levels of transient overvoltage, spikes up to 8,000 V, that can occur in industrial and utility environments. This is especially important for scenarios you may encounter in environments like industrial plants, factories, and hospitals where critical equipment cannot be taken offline.

The patented Smart Sensor available only on the Fluke 2062 Receiver, makes wire tracing faster and easier. It locates and displays energized wires within walls, floors, and ceilings on a high-resolution 3.5-inch TFT LCD color display. Embedded help screens on the display makes use easy, whether you’re a novice or an expert. While the tip sensor provides an audible tone when locating wires, the Smart Sensor helps visualize and pinpoint the orientation of energized wires, eliminating guesswork.

Whether troubleshooting electrical wiring and equipment in residential homes, commercial buildings, or high-voltage utility plants, the Fluke 2062 can find breaks or opens and shorts. Its different modes and functions give you the flexibility to troubleshoot a wide range of electrical wiring and circuitry problems you may encounter on the job.

The 2062R Receiver detects the signal in wires and cables using two methods:

Passive tracing without the transmitter for non-contact voltage detection and active tracing with the transmitter for all other modes.

The receiver’s tip sensor can trace wires in corners, tight spaces, and junction boxes.

• Smart Sensor mode for energized wire detection and visualization on the large color LCD
• Tip Sensor mode for more precise detection of a wire
• Breaker mode for easy breaker and fuse identification based on the highest recorded signal detected from the transmitter
• Non-Contact Voltage Detection mode to trace energized wires without the use of the transmitter

The 2000T Transmitter works on energized and de-energized circuits up to CAT IV 600 V and features high, low, and loop modes. These modes change the strength of the induced signal and can help provide more accurate results, depending on the circuit you’re tracing.

• High mode for normal energized and de-energized circuits
• Low mode for precision tracing with a low signal to reduce coupling to nearby wires and metal objects
• Loop mode for closed loop de-energized circuits

The 2000T automatically senses whether the system is energized or de-energized and selects a 6 kHz or 33 kHz output frequency. Eight receiver sensitivity levels mean more flexibility and accuracy when tracing.

The Fluke 2062 Advanced Pro Wire Tracer Kit conveniently comes with everything required to start tracing wires and circuits. The accessory kit includes test leads, test probes, blade and round outlet adapters, and alligator clips to connect the transmitter to electrical systems. Connecting the transmitter to a bare conductor with the included alligator clips and test leads will always provide the most accurate results.

However, in situations where a direct connection to a bare conductor is not available, the included i400 AC Current Clamp can be used with the “Loop” mode to induce a boosted 6 kHz signal through the insulation. The kit also includes a magnetic hanger strap, batteries, and a hard carrying case.