• DIP test fixture provides a connection to SMD DUT for testing
• Maximum operating voltage: 10 kV
• Protection: Cover with Interlock software
• DUT dimension (row spacing): Max. 18mm

The B195002 DIP test fixture provides the connection to SMD DUT for testing.

1 - RTN/Low: This terminal connects to the RTN/LOW terminal on the high voltage module of the 19501 partial discharge tester, which is a low potential terminal. This terminal is almost equal to the ground terminal on the chassis.

2 - Low Contact: This terminal connects to the HVCC-RTN terminal on the high voltage module of the 19501 partial discharge tester.

3 - HV Contact: This terminal connect to the HVCC-HV terminal on the high voltage module of the 19501 partial discharge tester.

4 - HV: This terminal connects to the HV terminal on the high voltage module of the 19501 partial discharge tester. Do not touch during testing and when the DANGER light is on.

5 - Micro Switch: This switch connects to the Interlock terminal on the fixture's rear side. When the acrylic cover is closed, the Interlock terminal will be short-circuited.

1 - Interlock: Please use the enclosed wire to connect to the Interlock terminal on the high-voltage module of the 19501 partial discharge tester. The test starts only when the acrylic cover is closed, making the micro switch short-circuit.

2 - GND: Please use the enclosed ground wire to connect the GND terminal on the high voltage module of the 19501 partial discharge tester.