| VIDEO |
| Inputs |
Two 270 Mb/s 4:2:2 serial digital video conforming to ITU-RBT.601 and SMPTE 259M-C standards |
| Connectors |
BNC female |
| Impedance |
Hi-Z loop thru |
| Return Loss |
≤-18 dB to 270 MHz |
| Level |
800 mV p-p |
| Equalization |
Automatic equalization for a minimum of 200m of 8281 |
| ANALOG REFERENCE |
| Input |
Composite video, blackburst, or composite sync |
| Connectors |
BNC female |
| Impedance |
Hi-Z loop thru |
| Return Loss |
≤-40 dB to 5 MHz |
| Sync Level |
143 mV to 600 mV |
| SYNCHRONIZATION REQUIREMENTS |
| Internal Reference |
Derived from serial A or serial B data or free running internal source |
| External Reference |
External reference will synchronize sweeps |
| VERTICAL DEFLECTION SYSTEM |
| Flat |
Y channel to 5 MHz ≤2% (±0.2 dB) CB CR channels to 2.5 MHz ≤2% (±0.2 dB) |
| Low Pass |
3 dB attenuation at 1 MHz. Low pass response (<10 kHz) within 1% (±1 dB) of Flat response |
| Differentiated Step |
For a non-modulated 5 step input with each step being 140 mV ±1%, the spikes produced by the filter are 500 to 700 mV. The difference between amplitudes will be less than ±2% of the first spike's amplitude. |
| Transient Response |
Less than 5 mV of preshoot and/or overshoot at full scale. Flat mode using sin2 pulse bar signal |
| Pulse To Bar Ratio |
0.99-1 to 1.01-1 |
| Tilt - Field Rate Square Wave or Vertical Window Or 25 μs Pulse Signal |
≤1% |
| Vertical Magnification |
x1 or x5 |
| HORIZONTAL DEFLECTION SYSTEM |
| Field Rate Time Base |
Equal to x1, x2, or x3 of the field rate of applied video or external reference (User selected Parade modes) |
| Line Rate Time Base |
Equal to x1, x2, or x3 of the H line rate of applied video or external reference (User selected Parade modes) |
| Sweep Magnification |
x1 or x10 |
| Timing Accuracy |
1H, HMag (0.5μs/div) ±2% |
| Linearity |
2% or less over complete horizontal position range excluding first and last major division |
| CALIBRATOR |
| Waveform Mode Frequency |
100 kHz ±0.1 kHz, synchronizes in H sweep modes providing reference for sweep and magnifier calibration |
| Amplitude |
700 mV ±0.5% |
| Vector Mode |
Provides vector centering dot |
| MULTIPLE DISPLAY |
| Waveform Overlays (H MAG) |
±100 ns - Relative,br> ±1.5 mV - Relative |
| Vector Overlays |
±1.5 mV - Relative |
| AUDIO |
| Inputs |
Balanced analog audio, AC coupled |
| Connector |
15-pin D-sub, female |
| Impedance |
Approximately 20 k ohms |
| Level |
0, +4, +8, or +12 dBm internally selectable (factory set to +4dBm) |
| Phase Matching |
Less than a trace width separation at 20 kHz |
| Displays |
Audio may be displayed alone or in any combination with waveform and/or vector |
| CONTROL |
| Inputs |
4 Contact closure inputs with common return - Dry Contacts |
| Connector |
15-pin D-sub (Shared with Audio) |
| Controls |
Each input will cause a system memory to be recalled. One input per memory |
| Outputs |
1 Dry Contact Closure consisting of
1 Normally Open contact
1 Normally Closed contact
1 Common return |
| Connector |
15-pin D-sub (Shared with Audio) |
| Controls |
Contact closure will become energized when an EDH, GAMUT, or Data error is detected. Contact will remain energized for 5 seconds |
| POWER REQUIREMENTS |
| Power Input |
90 to 260 VAC, 50/60 Hz, nominal |
| Power Consumption |
70 VA |
| TVM-821D/DC |
| Power Input |
10-16 VDC |
| Power Consumption |
6.5 AMP maximum, operating 20 AMP maximum inrush upon power on |
| Power Connector |
Dual binding posts |
| MECHANICAL |
| Display Size |
8 x 10 cm |
| Dimensions |
Height: 5.25'' (13.34 cm)
Width: 8.5'' (21.6 cm)
Depth: 17.75" (45.1 cm)
Weight 12 lb (5.45 kg) |
| ENVIRONMENTAL |
| Operating Temperature |
0° to 50°C |
| Storage Temperature |
-40° to 75°C |
| Humidity |
90% maximum (non-condensing) |
| STANDARD ACCESSORIES |
Operator's Manual
Terminator
Power Cord |
| OPTIONS |
Service Manual
SSC-1 Single standard case
PTC-1 Portable case with extendable sun hood and 20° folding stand
DRC-2A Double Rackmount Case
BLK-1 Blank panel for left or right side of DRC-2A
EPC EPC European Power Cord
EPC-UK United Kingdom Power Cord
EPC-AA Australia Power Cord |
;)
