|
Fluke 789/TEC ProcessMeter
Click image to enlarge
Fluke 789/TEC Kit
Click here for pricing
information
 Virtual Demo
|
Loop Power Supply mA Source and Simulate
The Fluke 789 ProcessMeter was the first tool to combine a loop calibrator with a DMM to give process
technicians double the power in one tool. Now it's even better – the ultimate loop calibration multimeter – the Fluke 789 ProcessMeter. The 789 has a display
that's not only twice as large, but also twice as bright with two levels of backlighting. And with its built-in, selectable 250 ohm HART resistor, it eliminates the need to carry
a separate resistor with you. Now process technicians can do a lot more while carrying a lot less.
|
Fast, High Accuracy Temperature Measurement
- Converts Fluke 789 to a thermometer via standard banana plugs
- Uses Type-K thermocouples with mini-connectors
- Switch selectable for ºC or ºF
- Low-cost, powered by standard 9V battery
- Battery test instructions included
Industrial Test Lead Set
Set consists of silicone-insulated TL22 Flexible Test Leads (red and black),
stainless-steel TP20 Industrial Test Probes (red and black), and AC20 Industrial Alligator Clips (red and black). 63" (1.6 m).
Suggested for Electrical/HVAC applications. Overvoltage Category III per IEC 1010, 10A rating. Shrouded right-angle connectors.
UL 3111-1 Listed.
Vinyl Case
Large vinyl soft case with water resistant zipper and one inside pocket for test
leads or small accessories. Convenient 3" (76 mm) belt loop accommodates tool belts.
|
;)
